General Kazan
Manufacturer of industrial steam, hot water, superheated water and thermal oil boilers.
About
Production profile
Company type
Activity types
Production capabilities
Materials worked
Certifications
Export profile
Industries served
Activity categories
Map
Location is approximate, based on the address. · © OpenStreetMap
Factory gallery
Products
Thermal Oil Boiler
Thermal oil boilers raise temperature up to 300°C at atmospheric pressure. Thermal oil is the heat carrier in the system. It does not leave sediment, does not form scale and does not cause corrosion, and it needs no conditioning. Under normal climate the circuit does not freeze in winter. The set temperature can be adjusted up to 300°C. Besides high-temperature duty, the boiler can also be used when steam, superheated water or hot water has to be produced.
Hot Water Boiler
The hot water boiler comes online in a short time and is described as raising boiler efficiency. It is a three-pass, counter-pressure boiler with a large furnace in which the flame reverses. It can be fitted with an eco panel and a three-way valve that set the flow temperature from the outdoor temperature. The manufacturer lists apartments, hotels, hospitals and factories as heating uses. It is built as an industrial boiler for gas, liquid or solid fuel according to the site’s heat capacity and temperature need.
Scotch Type Steam Boiler
The Scotch steam boiler is a three-pass unit. Flame and flue gas from combustion travel across sufficient heating surfaces so that maximum heat transfer is achieved before the gas leaves to the stack without low-temperature corrosion, giving high boiler efficiency. It responds to sudden steam draws. It has a wide evaporation surface, steam volume and a large corrugated furnace. After manufacture it is hydraulically tested at the pressure calculated by the standard. Smoke tubes are reached from the front doors, the furnace from the large rear explosion door, and the water side from the manhole and at least two hand holes. The design is high-pressure, fire-tube and cylindrical, to TS EN 12953, TRD, DIN and EN. Shell, tube plates and furnace are P265GH or P355GH boiler plate to EN 10028; smoke tubes are boiler tube to EN 10216 or EN 10217.
Services
Turnkey Installation and Commissioning
After manufacture the boiler is delivered to the plant and, under the agreement, handed over either turnkey with on-site installation or ex-works, then commissioned by the company’s crews. Fabrication uses cutting, bending and welding equipment. The product is manufactured and tested to the 2014/68/EU pressure equipment directive and to TSE, DIN and EN. Materials are chosen for the working temperature and pressure, and welds are made by welders tested to TS EN ISO 9606-1. The boiler is insulated with materials and methods that keep heat loss low, then started up on site.
Boiler Engineering
On request, General Kazan visits the plant and identifies the fuel that is lowest cost and easiest to obtain or transport in that region. Options reviewed are gas fuels such as natural gas, LNG and LPG, liquid fuels such as diesel, light oil and heavy oil, and solid fuels such as coal, pellet, olive pomace and hazelnut shell. Thermal capacity and temperature of the production site are set, and a water analysis is arranged for local water quality. The unit is located to occupational-safety criteria and designed for the workplace. The steam, hot water, superheated water or thermal oil boiler type is then released to manufacture.
After-Sales Technical Service
Once commissioned, the equipment stays under the after-sales service crews for as long as it operates. Periodic and annual maintenance keep the boiler efficient, safe and economical. The service covers industrial heat boilers such as steam boilers, hot water boilers, superheated water boilers and thermal oil boilers. The same crews that commission the unit after manufacture also carry out this follow-up.